Page 1 of 1

Question about the saloon table

PostPosted: Sun Nov 04, 2018 9:55 pm
by andyv94
So when I bought my boat the previous owner for reasons only himself knows, basically cut the original table in half.

So I had one of the yards here in Puerto Rico make me one based on the boat drawings, they didn’t do a bad job with the shape, it’s the damn thickness that it’s wrong. They ended up using marine plywood (I think) and plastic laminate to finish it off. So the problem is you can’t lean on it because it gives some and it’s not the steardiest of tables which sucks. I’ve been in other 33’s and I love the original sturdy as.....tables

Can anybody tell me the thickness of their table and if the used teal or which material!?
Thank you

Re: Question about the saloon table

PostPosted: Mon Nov 05, 2018 3:57 pm
by bramfam
Ours appears to be teak. It is solid as .... as you mentioned. I'll try to give the thickness a measure next weekend, although that will be tricky due to the fiddle rails.

Re: Question about the saloon table

PostPosted: Mon Nov 05, 2018 6:41 pm
by andyv94
Thank uou

Re: Question about the saloon table

PostPosted: Mon Nov 19, 2018 8:54 pm
by Bill
Andy,

Ours is easily 1" thick. I am sure it is teak ply, not solid, the fiddle rails are roughly 1.75" tall, flush with the bottom, solid teak.