Sound insulating engine room
4 posts
• Page 1 of 1
Sound insulating engine room
by mitchk » Thu Jun 28, 2007 3:18 pm
SV Camino HC33, We are having our engine pulled out saturday morning. I need to replace all 4 engine mounts and do some maintenance on the heat exchanger. Figured while I was doing all of that I would just go ahead and pull the engine and re-wire, re-plumb, paint and sound insulate the engine compartment. Any suggestion on what type of insulation wouold be appreciated? Also considering installing a 12 volt blower to help remove the heat from the engine room but cannot figure out where to vent it outside the boat? I dont really want to bore a big hole anywhere that water could get in? I am not even sure if this is nedded?
Mitch and Deb Karlson
SV Camino
1986 HC33T #104
Seabrook, Texas
SV Camino
1986 HC33T #104
Seabrook, Texas
- mitchk
- Moderator
- Posts: 236
- Joined: Thu Jul 13, 2006 3:26 pm
- Location: Seabrook, Texas
by mike » Fri Aug 17, 2007 10:20 am
200 ton Master
Past Owner Jolly Swagman - HC 43t Cutter Hull# 110 1987
http://www.eskside.co.uk/william_riley/mike_coates.htm
Past Owner Jolly Swagman - HC 43t Cutter Hull# 110 1987
http://www.eskside.co.uk/william_riley/mike_coates.htm
- mike
- Captain
- Posts: 1132
- Joined: Mon Jul 10, 2006 7:24 am
- Location: Whitby England
by sv_bruadair » Sun Aug 19, 2007 6:17 pm
-
sv_bruadair - First Mate
- Posts: 354
- Joined: Mon Sep 04, 2006 5:16 am
Engine room
by mitchk » Mon Aug 20, 2007 1:32 pm
Mitch and Deb Karlson
SV Camino
1986 HC33T #104
Seabrook, Texas
SV Camino
1986 HC33T #104
Seabrook, Texas
- mitchk
- Moderator
- Posts: 236
- Joined: Thu Jul 13, 2006 3:26 pm
- Location: Seabrook, Texas
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests